What is a Stainless Steel Wire Rope Clip? Also termed as a clamp, wire rope clamp, U-clip or U-clamp, a stainless steel wire rope clip is used for fixing up the loose end of the loop back to the wire rope. Usually, it consists of a U-shaped bolt, a forged saddle and two nuts. How to use wire rope clips properly? Inspecting the wire rope clip before use First of all, the wire rope clips must be inspected well before using them which will make sure that all the markings are legible, the clip is free from any cracks, gouges or nicks, the clip has the correct dimension, and the clip is not a repaired or reshaped one as it affects the performance. The wire rope clip bridge must be placed on the load bearing part of the rope always and the U-bolt must be placed at the dead end of the rope. Now the wire rope length needs to be turned back enough so that the minimum required number of clips can be installed to it. The first clip must be placed at one bridge width distance from the turned back dead end of the rope and then the nuts must be tightened according to the specified torque. Now, after successfully placing the first clip, the second clip needs to be positioned immediately against the stainless steel thimble but in such a point that while tightening the clip it doesn’t create any damage at the outer wires of the wire rope after which the nuts need to be tightened firmly but not to the specified torque. Lastly, one more clip must be placed between the first and second clip on the wire rope in such a way that they are separated by at least 1½ times the clip width. Now a light tension needs to be applied to the rope and tighten the nuts evenly alternating until the specified torque is reached. Conclusion:
If you are looking for high quality stainless steel wire rope clip and stainless steel thimble then visit QMH.
0 Comments
|
Author
QMH Inc. is a specialized stainless steel hardware wholesale company serving the rigging, marine, fastener and architectural industries since 1996. Archives
May 2020
Categories
|